Skip to Content
  1. All Products
  2. AL Modular System
  3. Other accessories
  4. ESD rubber profile for slot C10
Profilato di gomma ESD per cava C10

ESD rubber profile for slot C10

https://leanproducts.eu/web/image/product.template/3206/image_1920?unique=1d9bc53

Conductive EPDM rubber profile that hooks onto the cross member with slot C10: covers hard edges and works as a footrest on workstations, including ESD ones. 30000 mm roll.

Read more ↓
Code: 3842562090
Length: 30,000
  • Slot mm
  • Technical notes
  • Length mm
  • ESD
  • Material
  • Length

This combination does not exist.

Log in to see prices and buy
You have already submitted a query for this product today.
Bosch 5S5
Contact Us
Request a quote
We reply within 1 working day
Download PDF data sheet

Specifications

ESD yes
Technical notes Rubber profile/footrest; leakage resistance 10^4…10^9 Ω
Length mm 30000
Slot mm 10
Material EPDM
Length 30000
Tags
Tags
Bosch 5S5

It hooks onto the cross member with a 10 mm slot from above and from the front, usually the lower cross member of the workstation. No screws needed.

This code is the full 30000 mm roll. If you only need a few pieces, choose the ESD rubber profile C10 cut to length.

It is the width of the profile slot and determines which accessories you use. Slot C6 (6 mm) is for 20 series profiles, C8 (8 mm) for the 30 series, C10 (10 mm) for profiles from the 40 series upwards. Nuts, screws, brackets and cover caps are chosen by slot: each accessory's product page shows the right one.

Yes. You can order the full bar or the piece cut to the length you need: we do the cutting ourselves, in our workshop. Each profile's product page shows the maximum bar length and the minimum cut length.

Look at the moments of inertia Ix and Iy: the higher they are, the less the profile deflects under load. For the same section, “L” profiles are lightened and deflect a little more. For long spans or high loads move to a larger section or a tall profile (e.g. 45x90 instead of 45x45). If you send us drawing and loads, we will check the choice.

The T-nut is inserted from the front into the slot, even in an assembled structure, and positions itself when you tighten the screw: it is the standard choice for fixing accessories. The sliding block withstands higher forces, but normally has to be inserted from the profile end before closing the frame; spring versions stay where you put them.

The simplest way is the bracket, which joins two profiles at 90° with screws and nuts in the slot, without machining. For end, T, 45° or three-way connections there are dedicated connectors, some of which require profile machining as stated on their product page.

Yes, for several accessories (for example cover caps, hinges and nuts) there are conductive ESD versions, indicated in the name or variant. Tell us which EPA area you work in and we will confirm the components to use.

On each product page you will find the MGE catalogue pages to download as PDF, with dimensioned drawings and technical data; the Specifications tab shows the data for the variant you have chosen.

Yes. Send us the parts list or a sketch with dimensions: we give you codes, quantities and cut lengths and prepare the kit with profiles already cut and the accessories.