Skip to Content
  1. All Products
  2. AL Modular System
  3. Other accessories
  4. Radial compensation

Radial compensation

https://leanproducts.eu/web/image/product.template/3618/image_1920?unique=1d9bc53

Grey PA insert for T-joints between profiles with central bolt or quick connector: prevents gaps and sharp edges at the joint. For 30x30 C8, 40x40 C10 and 45x45 C10.

Read more ↓
Code: 3842551026
from
not with
options
Prices per piece + VAT
Prices per pack of %s + VAT
Prices per pack of %s pcs + VAT
colors
only
of
available
  • Section
  • Colour
  • Technical notes
  • Dimensions mm
  • Slot mm
  • Material
  • Brand

This combination does not exist.

Log in to see prices and buy
You have already submitted a query for this product today.
Bosch 5S1
Contact Us
Request a quote
We reply within 1 working day
Download PDF data sheet

Specifications

Technical notes Avoids gaps in T-joints with central bolt/quick connector; reduces load capacity
Colour signal grey RAL 7004
Dimensions mm 30x30
Section 30x30 C8
Slot mm 8
Material Polyamide (PA)
Brand Bosch Rexroth
Tags
Tags
Bosch 5S1

Yes, it reduces it: the connection between the profiles holds less than without the insert. Use it where finish matters, for example on guards and workstations, and check the most heavily loaded joints before fitting it.

With T-joints made with a central bolt or quick connector, on the butting profile. Observe the hole distance from the end of the profile specified for the connection.

It is the width of the profile slot and determines which accessories you use. Slot C6 (6 mm) is for 20 series profiles, C8 (8 mm) for the 30 series, C10 (10 mm) for profiles from the 40 series upwards. Nuts, screws, brackets and cover caps are chosen by slot: each accessory's product page shows the right one.

Yes. You can order the full bar or the piece cut to the length you need: we do the cutting ourselves, in our workshop. Each profile's product page shows the maximum bar length and the minimum cut length.

Look at the moments of inertia Ix and Iy: the higher they are, the less the profile deflects under load. For the same section, “L” profiles are lightened and deflect a little more. For long spans or high loads move to a larger section or a tall profile (e.g. 45x90 instead of 45x45). If you send us drawing and loads, we will check the choice.

The T-nut is inserted from the front into the slot, even in an assembled structure, and positions itself when you tighten the screw: it is the standard choice for fixing accessories. The sliding block withstands higher forces, but normally has to be inserted from the profile end before closing the frame; spring versions stay where you put them.

The simplest way is the bracket, which joins two profiles at 90° with screws and nuts in the slot, without machining. For end, T, 45° or three-way connections there are dedicated connectors, some of which require profile machining as stated on their product page.

Yes, for several accessories (for example cover caps, hinges and nuts) there are conductive ESD versions, indicated in the name or variant. Tell us which EPA area you work in and we will confirm the components to use.

On each product page you will find the MGE catalogue pages to download as PDF, with dimensioned drawings and technical data; the Specifications tab shows the data for the variant you have chosen.

Yes. Send us the parts list or a sketch with dimensions: we give you codes, quantities and cut lengths and prepare the kit with profiles already cut and the accessories.