Skip to Content
  1. All Products
  2. AL Modular System
  3. Connection elements
  4. Connectors and fittings
  5. Fastening set QV

Fastening set QV

https://leanproducts.eu/web/image/product.template/2863/image_1920?unique=1d9bc53

Fastening set QV with M8x40 screw for joining two profiles with slot C10 at right angles: good tool access during assembly, load capacity 1000 N, tightening torque 25 Nm. Requires standard F1 milling on the profile.

Read more ↓
Code: 3842146972
  • Brand
  • Slot mm
  • Load capacity Fmax N
  • Technical notes
  • Thread
  • Tightening torque Nm
  • Material
  • Slot mm

This combination does not exist.

Log in to see prices and buy
You have already submitted a query for this product today.
Bosch 5S1
Contact Us
Request a quote
We reply within 1 working day
Download PDF data sheet

Specifications

Brand Bosch Rexroth
Technical notes Fastening set QV, screw M8x40; standard milling F1
Thread M8
Load capacity Fmax N 1000
Tightening torque Nm 25
Slot mm 10
Material Zinc-plated steel
Slot mm 10
Tags
Tags
Bosch 5S1

The QV set holds 1000 N, but it is not designed for bending of the joint. If the crossbar is cantilevered or carries side loads, use a T-connector or a bolt connector.

It is the standard profile machining specified for this connection and must be done before assembly: without F1 milling the set cannot be fitted.

It is the width of the profile slot and determines which accessories you use. Slot C6 (6 mm) is for 20 series profiles, C8 (8 mm) for the 30 series, C10 (10 mm) for profiles from the 40 series upwards. Nuts, screws, brackets and cover caps are chosen by slot: each accessory's product page shows the right one.

Yes. You can order the full bar or the piece cut to the length you need: we do the cutting ourselves, in our workshop. Each profile's product page shows the maximum bar length and the minimum cut length.

Look at the moments of inertia Ix and Iy: the higher they are, the less the profile deflects under load. For the same section, “L” profiles are lightened and deflect a little more. For long spans or high loads move to a larger section or a tall profile (e.g. 45x90 instead of 45x45). If you send us drawing and loads, we will check the choice.

The T-nut is inserted from the front into the slot, even in an assembled structure, and positions itself when you tighten the screw: it is the standard choice for fixing accessories. The sliding block withstands higher forces, but normally has to be inserted from the profile end before closing the frame; spring versions stay where you put them.

The simplest way is the bracket, which joins two profiles at 90° with screws and nuts in the slot, without machining. For end, T, 45° or three-way connections there are dedicated connectors, some of which require profile machining as stated on their product page.

Yes, for several accessories (for example cover caps, hinges and nuts) there are conductive ESD versions, indicated in the name or variant. Tell us which EPA area you work in and we will confirm the components to use.

On each product page you will find the MGE catalogue pages to download as PDF, with dimensioned drawings and technical data; the Specifications tab shows the data for the variant you have chosen.

Yes. Send us the parts list or a sketch with dimensions: we give you codes, quantities and cut lengths and prepare the kit with profiles already cut and the accessories.

Accessory Products